GPS Module

D1010

New product

Ublox NEO-6M GPS Module Aircraft Flight Controller

More details

This item has been sold

22
times

RM39.00

Add to wishlist

This product is covered by .
This product is covered by                 .

Data sheet

IC
- Model Ublox Neo
Specifications
- Connection TTL, GPS
Power
- Input Voltage (recommended) 3.3-5 Volt
- Operating Voltage 2.7-5 Volt
Memory
- EEPROM save configuration parameter data
DIMENSION
- Depth (mm) 8
- Length (mm) 35
- Width (mm) 25
- Weight 25 - 50 gram

More info

Specifications:
1. Interface features: TTL level compatible 3.3V / 5V microcontroller system
2. Reception characteristics: 56 channels, GPS L1 (1575.42Mhz) C / A code, SBAS: WAAS / EGNOS / MSAS
3. Positioning accuracy: 2.5mCEP (SBAS: 2.0mCEP)
4. Update rate: Maximum 10Hz (default 1HZ)
5. Acquisition Time: Cold start: 27S (fastest)
6. Hot Start: 1S
7. Capture tracking sensitivity: -162dBm
8. Oscillator: TCXO (+/- 0.5PPM)
9. Communication Protocol: NMEA (default) / UBX Binary
10. Serial communication baud rate: 9600
11. Operating temperature: -40 degrees Celsius to 85 degrees Celsius
12. Operating voltage: 2.7V-5.0V (VCC pin input)
13. Operating Current: 35mA
14. TXD / RXD Impedance: 510 Ou

Features:
1. Use NEO-6M module comes with high-gain antenna.
2. TTL level compatible with 3.3V / 5V systems.
3. Comes IPX interface, you can connect a variety of active antenna.
4. It can be charged with a rechargeable backup battery, it can be powered down to save ephemeris data to achieve hot start
5. EEPROM power-down save configuration parameter data
6. With LED signal indicator
7. Instructions:
(To access the MCU as an example)
VCC: connect 3.3V / 5V
GND: connect GND
TXD: connect MCU.RX
RXD: connect MCU.TX
8.After get the module, Firstly, you should module and PC via serial port (it must be go through level conversion chip such as MAX232).
Open serial debugging assistant, as the following settings:
1. 9600 (default), 8 data bits, 1 stop bit, no parity, no flow control.
2. After the setup is complete, open the appropriate serial port, you can see the corresponding data output in the serial debugging assistant.

Reviews

Grade 
17/09/2014

This is a very good GPS module

Works as expected. Reading out the data is pretty fast. As it is 3.3V compatible it works fine on arduino due out of the box. The circuit in the picture reads data from the GPS module and sends the data to a computer through an UDP packet. Wifi module is in AP mode, computer is connected as client to the esp8266

Write a review

GPS Module

GPS Module

Ublox NEO-6M GPS Module Aircraft Flight Controller

Customers who bought this product also bought:

30 other products in the same category: